Jabsco Ballast Pump

Includes deutsch connector for easy installation in seen in MasterCraft, Supra, Moomba and Nautique boats with a factory installed ballast system.

If replacing pumps on 2002-2012 MasterCraft boats, you will need to purchase the MasterCraft Ballast Wiring Adapter.

The Jabsco Wakeboard Ballast Puppy is designed to pump water into Wakeboard Ballast Tanks and when reversed will also pump water out of them. It has a flow rate of 540 gallons per hour, so it can fill most ballast tanks in about five minutes. It is equipped with a Run-Dry Protection Device to automatically shut-off the pump and protect the impeller from run-dry damage should the pump be mistakenly left on after the Ballast Tank is empty. The Ballast Puppy also features ignition protection which allows the use of this pump in the engine compartment unlike its less expensive cousin the Simer Pump. This is the same pump found used to fill and drain OEM ballast systems in Mastercraft Boats, Supra Boats, Moomba Boats, Nautique Boats and Centurion Boats.

Inlet/Outlet Thread: 0.50 inches FNPT Flow Rate: 540 GPH Self-priming: Yes Safety Features: Self-priming and On Air-Locking

Use the boat part look up below to ensure you are purchasing the correct part for your boat.