Indmar

Indmar Fuel Pump On Engine For TBI & LT-1 **THIS IS THE CONVERSION KIT THAT INDMAR NOW OFFERS. THE ORIGINAL ON ENGINE FUEL PUMP IS NO LONGER MADE. THE PHOTO IS OF THE ORIGINAL FUEL PUMP** Bring...

2015 Indmar Ford Raptor 6.2L Oil Filter Fits all Indmar Ford Raptor 6.2L based marine engines for the 2015 model year only. Marine engines should get an oil and filter change every 50 hours of run...

Indmar 5.7L Spark Plug Wire Set Get the spark your engine needs with a new spark plug wire set from MasterCraft. This wire set fits these 2005 and older 5.7L Engines - MCX, RTP-1, and Predator...

Indmar Water Pump Impeller This Indmar Water Pump Impeller fits most Indmar marine engines found in (Malibu, Supra, Moomba, etc.) and almost every MasterCraft produced from 1987 until the change to...

Indmar Raw Water Pump Indmar Raw Water Pump fits Ford and GM engines like std and HO 351, TBI, MCX, RTP, Predator, LQ9, LY6, 8.1. Johnson crankshaft mounted pump. Includes a new impeller and gasket...

Indmar Thermostat Gasket This is commonly used on Indmar 350 Thermostat Gasket for GM 5.0 and 5.7 small block engines including the RTP-1, MCX, Assault, Monsoon, and many others. This is a 2 bolt...

Indmar LT1 Thermostat Gasket This MasterCraft Indmar LT-1 Corvette thermostat gasket was an engine option in MasterCraft boats from 1993 to 1999. It is used to seal the 160 degree drilled thermostat...

Indmar 160 Degree Thermostat Indmar 160 degree thermostat for GM based 5.0 and 5.7 engines. Use the boat part look up below to ensure you are purchasing the correct part for your boat.  

Indmar Thermostat Gasket This thermostat gasket is commonly used on many late 80's to early 90's Indmar engines. This gasket measures 3 3/8" across (at the widest point) and 4 1/4" long. This part is...

Rotor (86-Older) Prestolite Fits Ford and GM based V8 engines 1986 and older with a Prestolite distributor. Rotor only.Note: There were a FEW 1987 boats built that had the "old" CLIP-ON type...

Indmar 160 Degree Thermostat LT1 Indmar 160 degree thermostat for Corvette LT-1 engines. This thermostat features two small holes that are drilled through to allow air to pass through the thermostat...

Indmar Thermostat Gasket This thermostat gasket is commonly used on Indmar 350 block engines including the RTP-1, MCX, Assault and many others. This is a 3 bolt gasket used on the bottom half of the...