Indmar

Indmar LT1 Thermostat Gasket This thermostat gasket is used on the Indmar LT-1 Corvette engines which were optional in MasterCraft boats from 1993 to 1999. It is used to seal the 160 degree drilled...

Indmar 160 Degree Thermostat Indmar 160 degree thermostat. Use the boat part look up below to ensure you are purchasing the correct part for your boat.  

Indmar Thermostat Gasket This thermostat gasket is commonly used on many late 80's to early 90's Indmar engines. This gasket measures 3 38/" across (at the widest point) and 4 1/4" long. This part...

Rotor (86-Older) Prestolite Fits Ford and GM based V8 engines 1986 and older with a Prestolite distributor. Rotor only.Note: There were a FEW 1987 boats built that had the "old" CLIP-ON type...

Indmar 160 Degree Thermostat Drilled Indmar 160 degree thermostat for Corvette LT-1 engines. This thermostat features two small holes that are drilled through to allow air to pass through the...

Indmar Thermostat Gasket This thermostat gasket is commonly used on Indmar 350 block engines including the RTP-1, MCX, Assault and many others. This is a 3 bolt gasket used on the bottom half of the...

Indmar Spark Plug Wire Set | 755007 Get the spark your engine needs with new spark plug wire set. Fits Ford 351w, 302(5.8, 5.0), based small blocks with either a Prestolite or a Mallory distributor...

IFord 351 HO 285 HP Spark Plugs Fits all HO Ford 351w engines like 285HP Indmars, PCM Pro Boss GT-40, etc. with GT-40 heads. Set of 8. Specs; Plug gap .035".Please note: No returns will be accepted...

Prestolite Distributor Rotor (1987 & newer) Fits Ford and GM based V8 engines 1987 and newer with a Prestolite distributor. This is the Rotor only. These engines were used by MasterCraft, Malibu,...

Indmar Oil Pressure Sender Genuine Indmar Oil Pressure Sender. This part is commonly found in Indmar engines in MasterCraft, Malibu, Supra and Moomba boats. Use the boat part look up below to...

Indmar Oil Cap Proper maintenance ensures that your boat performs in peak condition year after year. Indmar Engines offers this replacement oil cap for engines using steel valve covers and a...

Johnson Raw Water Pump Cover Plate Screw The Johnson Raw Water Cover Plate Screw fits almost all Indmar marine engines (Malibu, Supra, Moomba, etc.) and almost every MasterCraft produced from 1987...