Engine Parts

Indmar Oil Cap Proper maintenance ensures that your boat performs in peak condition year after year. Indmar Engines offers this replacement oil cap for engines using steel valve covers and a threaded oil cap. Please note this oil cap does NOT work with...

Sierra Oil Filter 18-7824 Proper maintenance ensures that your boat performs in peak condition year after year. Commonly referred to as the Short GM Filter this replaces   Chris-Craft: 16.81-08746 Crusader: 201104,Indmar: 50-1001 Mercruiser:...

Johnson Raw Water Pump Cover Plate Screw The Johnson Raw Water Cover Plate Screw fits almost all Indmar marine engines (Malibu, Supra, Moomba, etc.) and almost every MasterCraft produced from 1987 until the change to Ilmor engines in 2011. 5/16 Brass Hex...

Johnson Raw Water Pump Cover Plate The Johnson Raw Water Pump Cover Plate fits almost all Indmar marine engines (Malibu, Supra, Moomba, etc.) and almost every MasterCraft produced from 1987 until the change to Ilmor engines in 2011. The Johnson Raw Water...

Ford Oil Filter for Indmar & PCM Fits all Ford based 351 & 302 (5.8 & 5.0) engines. Marine engines should get an oil and filter change every 50 hours of run time. Keep your Ford based marine engine running at peak performance with this oil filter. Use...

Fake A Lake Inboard Engine Flush Fake-A-Lake is a simple solution for the occasional need to flush your engine, engine tune, winterize or anytime you need to run an inboard engine out of water. Fake-A-Lake is safe, the rubber cup compresses against your...

Indmar 140 Degree Thermostat Indmar 140 degree thermostat. Use the boat part look up below to ensure you are purchasing the correct part for your boat.  

Indmar Engine Block Plug Brass engine block plug from Indmar Marine engines. This is a 1/4 plug with hex head. Replace your worn block plug(s) regularly to speed up engine block drain time, winterization and more. Please note some engines may have 2...

Ilmor Ignition Coil Assembly - MV8V-1142 Maintain like-new performance for your Ilmor engine with these Ilmor specified ignition coils. These coils are designed as a direct replacement for your OEM coils. Ilmor IGN Coil ASSEM for MasterCraft boats...

Spark Plugs for 70's-'92 MasterCraft Boats Get the spark you are after in your MasterCraft boat with new MasterCraft Spark Plugs. Fits standard output Ford 351w, 302 (5.8, 5.0) engines 1975 through the early '90s from PCM and Indmar. Set of 8. Specs;...

MasterCraft Ilmor 6.0L 6.2L DRVE Belt Tensioner Ilmor’s belt tensioner reduces belt wear and ensures your engine’s drive belt is operating at peak performance and reliability. Ilmor DRVE Belt Tensioner for MasterCraft boats. Specifically designed by...

MasterCraft Boats Tune Up Kit Is your MasterCraft boat not running that well anymore? Give it a tune up with our specifically designed MasterCraft Tune Up Kit. Fits Ford & GM based V8 engines with Prestolite points distributor and SCREW-DOWN distributor...