Engine Parts

Indmar 160 Degree Thermostat Indmar 160 degree thermostat. Use the boat part look up below to ensure you are purchasing the correct part for your boat.  

PCM Raw Water Impeller GM 350/454 This impeller for your PCM Marine Engine will keep your boat from overheating by properly circulating water through the block and manifolds. We recommend replacing your engine impeller every 100 hours or annually to...

Ilmor Oil Pressure Sensor | MV8V-1013 Ilmor Oil Pressure Sensor for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for Ilmor engines. Use the boat part look up below to ensure you are purchasing the correct part for your boat.  

Rotor GM Gen 2 HEI distributor Fits GM based engines using Delco Gen 2 HEI distributor. Generally from 1994 to 2004. Like Indmarξ 310hp carb., MasterCraft TBI, early MasterCraft MCX, Malibu Monsoon, Assault, Apex, Pro Ski EFI. Rotor only.These engines...

Indmar Thermostat Gasket This thermostat gasket is commonly used on many late 80's to early 90's Indmar engines. This gasket measures 3 38/" across (at the widest point) and 4 1/4" long. This part is commonly found in MasterCraft, Supra, Moomba and...

GM Pre-Vortec Marine Spark Plugs Fits GM based pre-Vortec engines used by Indmar and PCM from 1997 and earlier. Carbureted and EFI's. These engines were run in many MasterCraft, Supra, Moomba and Malibu boats. Midwest MasterCraft is proud to offer tune...

Indmar Distributor cap GM Gen 2 HEI Fits GM based engines using Delco Gen 2 HEI distributor. Generally from 1994 to 2004. Like Indmarξξ 310hp carb., TBI, early MCX, Monsoon, Assult, Apex, Pro Ski EFI. Has brass terminals to resist corrosion. Cap only...

Ilmor Raw Water Pump Impeller (Closed Cooled and 7.4L) This Ilmor genuine impeller kit is made from top quality materials specifically formulated to provide peak performance for use in your Ilmor engine. Kit includes: impeller, gasket and o-ring. Use...

Ilmor Water Pump Impeller This Ilmor genuine impeller kit is made from top quality materials specifically formulated to provide peak performance for use in your Ilmor raw water pump. Kit includes: impeller and o-ring. This impeller is designed to work...

Bring your engine back to peak performance with this PCM Fuel Pump for your 302 or 351 Ford engine. Worn fuel pumps rob power from your boat especially at high RPM's so help out your MasterCraft or Correct Craft Nautique with this new fuel pump. This is...

Rotor (86-Older) Prestolite Fits Ford and GM based V8 engines 1986 and older with a Prestolite distributor. Rotor only.Note: There were a FEW 1987 boats built that had the "old" CLIP-ON type distributor cap still.Please note: No returns will be accepted...

Indmar 160 Degree Thermostat Drilled Indmar 160 degree thermostat for Corvette LT-1 engines. This thermostat features two small holes that are drilled through to allow air to pass through the thermostat. This is the thermostat which is located in the...