Engine Parts

Millenium Fuel Pump Fuel Filters Replace your clogged or damaged fuel filter on MasterCraft Boats with a Millennium style fuel pump. Everything you need to get your engine getting clean fuel again! Please note: No returns will be accepted on installed...

MasterCraft Fuel Sending Unit Fuel Sending unit for MasterCraft Boats. Replace your old or non-working fuel sending unit and never run out of gas again! Comes complete with installation instructions and replacement cork seal. This is the correct fuel...

PCM Thermostat Gasket This thermostat gasket was commonly found on PCM engines. Use the boat part look up below to ensure you are purchasing the correct part for your boat.  

Get the spark your engine needs with a new spark plug wire set from MasterCraft. This wire set fits these 2005 and older 5.7L Engines - MCX, RTP-1, and Predator. Please note: No returns will be accepted on installed MasterCraft parts.***Please note, this...

MasterCraft Muffler | 3.5" Horizontal W/50° Angle - 3.5" Outlet This is a genuine replacement fiberglass muffler for many MasterCraft ProStar boats. This muffler was typically used in direct drive boats made from 2009 to 2012 and features a 3.5" in and...

Ilmor Spark Iridium Plug Set of 8 (5.7L) | MV8V-1191 Ilmor Spark Plug Set for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for 5.7L Ilmor engines. Use the boat part look up below to ensure you are purchasing the correct part for your...

Indmar MasterCraft LT-1 Circulating Water Pump Water circulating pump for Indmar Corvette LT1 marine engines used in MasterCraft boat. Fits Indmar LT-1 engines used in MasterCraft boats. Comes with mounting gaskets.  Please note: No returns will be...

Circulating Water Pump for GM Engines This is a new circulating water pump for Indmar and PCM GM marine engines. This pump fits GM 5.0 and 5.7 Liter small block engines. This pump is Standard (LH) rotation. Comes with new mounting gaskets to ensure a...

Ilmor Spark Iridium Plug Set of 8 | MV8V-1192 Ilmor Spark Plug Set for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for 6.0L 6.2L Ilmor engines. Use the boat part look up below to ensure you are purchasing the correct part for your...

MasterCraft Fuel Pump Gasket Replace your fuel pump gasket every time you replace your fuel filter on your in-tank pump to ensure a proper fit. Please note: No returns will be accepted on installed MasterCraft parts. Use the boat part look up below to...

Indmar Water Pump Impeller This kit fits almost all Indmar marine engines (Malibu, Supra, Moomba, etc.) and almost every MasterCraft produced from 1987 until the change to Ilmor engines in 2011.   Your boats raw water pump is designed to use the...

PCM Raw Water Pump Fits PCM Ford based engines including 302 and 351 engines used in MasterCraft and Correct Craft boats. This is a new Sherwood belt driven pump.Keep your boat supplied with the right amount of water with this new raw water pump from...