Engine Parts

Ilmor Spark Iridium Plug Set of 8 | MV8V-1192 Ilmor Spark Plug Set for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for 6.0L 6.2L Ilmor engines. Use the boat part look up below to ensure you are purchasing the correct part for your...

MasterCraft Fuel Pump Gasket Replace your fuel pump gasket every time you replace your fuel filter on your in-tank pump to ensure a proper fit. Please note: No returns will be accepted on installed MasterCraft parts. Use the boat part look up below to...

Indmar Water Pump Impeller This kit fits almost all Indmar marine engines (Malibu, Supra, Moomba, etc.) and almost every MasterCraft produced from 1987 until the change to Ilmor engines in 2011.   Your boats raw water pump is designed to use the...

PCM Raw Water Pump Fits PCM Ford based engines including 302 and 351 engines used in MasterCraft and Correct Craft boats. This is a new Sherwood belt driven pump.Keep your boat supplied with the right amount of water with this new raw water pump from...

Indmar Raw Water Pump Fits Indmar Ford and GM engines like std and HO 351, TBI, MCX, RTP, Predetor, LQ9, LY6, 8.1. Johnson crankshaft mounted pump. New pump.Please note this pump DOES NOT FIT LT1 CORVETTE OR LTR ENGINES. Keep your engine running at the...

Indmar Thermostat Gasket This thermostat gasket is commonly used on Indmar 350 block engines including the RTP-1, MCX, Assault and many others. This is a 2 bolt gasket used on the top half of the thermostat housing, where the thermostat housing splits...

Mallory Oil Filter 9.57801 Proper maintenance ensures that your boat performs in peak condition year after year. Commonly referred to as the Short GM Filter this Mallory filter is slightly larger in size than the Sierra 18-7824. This filter...

PCM replacement part which fits MasterCraft Boats with a PCM 351 Ford engine. Will also fit an almost all PCM/Ford applications. Nothing like an overheated engine to ruin your weekend on the water. It is recommended that you change your impeller annually...

Indmar LT1 Thermostat Gasket This thermostat gasket is used on the Indmar LT-1 Corvette engines which were optional in MasterCraft boats from 1993 to 1999. It is used to seal the 160 degree drilled thermostat. Use the boat part look up below to ensure...

Hose formed "U" for LT1 engines Formed U hose for Corvette LT-1 engines from Indmar and MasterCraft boats. Fits Indmar LT1 engines- goes from the raw water pump to the thermostat housing. Midwest MasterCraft stocks MasterCraft boat parts. Please note:...

Ilmor Belt Tensioner for Serial #'s 000001-005366 The Ilmor tensioner pulleys is built with smoother surfaces and tighter dimensional tolerances, which translates to less vibration, and longer pulley life. Use the boat part look up below to ensure you...

MasterCraft Engine Tune Up Kit (86-older) Is your MasterCraft boat not running that well anymore? Give it a tune up with our specifically designed MasterCraft Tune Up Kit. This kit fits all Fits Ford & GM based V8 engines with Prestolite points...