Engine Parts

Indmar Thermostat Gasket This thermostat gasket is commonly used on Indmar 350 block engines including the RTP-1, MCX, Assault and many others. This is a 3 bolt gasket used on the bottom half of the thermostat housing where it meets the intake manifold...

Ilmor Thermostat Housing O-Ring The Ilmor remote thermostat housing mounting o-ring offers application-specific materials to give you a sealing solution with the performance and durability you can trust. This Thermostat Housing O-Ring is used with both...

Ilmor O2 Sensor Upstream | MV8V-1017 Ilmor specified oxygen sensor is the recommended replacement for your Ilmor engine. The sensors provide special feedback to your engine’s exhaust system by measuring the proportion of oxygen in the exhaust gases...

Circulating Water Pump for Indmar & PCM Ford Engines Fits all Ford based engines from Indmar, PCM, etc.ξ This is a Bi-rotational pump. This new water circulating pump comes with a new mounting gasket to ensure a proper fit on your boat motor. New pump...

MasterCraft Water Sending Unit Sender-Water X30/X45If you do not see your boat model and year combination please email parts@waterskis.com to get the correct part. *PLEASE NOTE: ALL SALES ON SENDING UNITS ARE FINAL, AND ARE NON REFUNDABLE Model...

Ilmor O2 Sensor Downstream | MV8V-1018 Ilmor specified oxygen sensor is the recommended replacement for your Ilmor engine. The sensors provide special feedback to your engine’s exhaust system by measuring the proportion of oxygen in the exhaust gases...

Ilmor Spark Plug Wire Set | PL00224 Ilmor’s spark plug wire set consists of a set of 8 wires, encased in a premium insulating material, connectors, and insulating boots and are the high-quality and trusted replacement for your Ilmor engine. Ilmor...

Long Flexible Funnel For Oil and Transmission Fluid Long Flexible Funnel Fine mesh screen filters out most foreign matter. Non splashing. Lightweight floating polyethylene plastic. Makes putting oil and transmission fluid into hard to reach places a...

Indmar Spark Plug Wire Set | 755007 Get the spark your engine needs with new spark plug wire set. Fits Ford 351w, 302(5.8, 5.0), based small blocks with either a Prestolite or a Mallory distributor. Set of 9 wires. Please note: No returns will be...

Ilmor Raw Water Pump Assembly Ilmor’s raw water pump assembly is specifically designed to keep your boat running cool and efficiently all season long. This factory direct part is tested and inspected prior to shipment, ensuring you receive a part you...

  This filter is no longer made and sold by MasterCraft. You can purchase the aftermarket replacement filter here -> Fuel Pump Filter for In-Tank Fuel Pumps - MasterCraft

Ilmor Oil Filter This genuine Ilmor oil filter is made of high quality materials designed specifically for your Ilmor engine to keep it free of debris and contaminants. For ALL Ilmor MasterCraft engines (5.3, 5.7, 6.0, 6.2L, & 7.4). Ilmor custom...

Ilmor Starter Motor The Ilmor starter is the component that gets your engine running, providing ultimate cranking power for reliable and consistent engine starts every time. Use the boat part look up below to ensure you are purchasing the correct part...

Indmar Ford Raptor 6.2L Oil Filter Fits all Ford Raptor 6.2L for the 2016 motel year and newer.Marine engines should get an oil and filter change every 50 hours of run time. Keep your Ford based marine engine running at peak performance with this oil...

Ilmor Knock Sensor w/Bolt | 1015 Ilmor Knock Sensor for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for 5.7L 6.0L 6.2L Ilmor engines.  Made with high-quality materials that ensure OEM specified performance.  Use the boat part...

  MasterCraft Ignition Switch Keep your boat starting like new every time with this genuine MasterCraft Parts Ignition Switch with keys. This switch is the replacement part for virtually all MasterCraft boats dating back to 1968. This switch...

IFord 351 HO 285 HP Spark Plugs Fits all HO Ford 351w engines like 285HP Indmars, PCM Pro Boss GT-40, etc. with GT-40 heads. Set of 8. Specs; Plug gap .035".Please note: No returns will be accepted on installed MasterCraft parts. Use the boat part look...

1.25" Wire Reinforced Hose This 1.25" wire reinforced hose is commonly found on marine engines and can be used in water or exhaust situations. This hose is reinforced with wire helix imbedded between plies of HD synthetic cord. It is resistant to...

Prestolite Distributor Rotor (1987 & newer) Fits Ford and GM based V8 engines 1987 and newer with a Prestolite distributor. This is the Rotor only. These engines were used by MasterCraft, Malibu, Supra and Moomba boats. Note: There were a FEW 1987 boats...

Indmar Oil Pressure Sender Genuine Indmar Oil Pressure Sender. This part is commonly found in Indmar engines in MasterCraft, Malibu, Supra and Moomba boats. Use the boat part look up below to ensure you are purchasing the correct part for your boat.