Engine Parts

Bring your engine back to peak performance with this PCM Fuel Pump for your 302 or 351 Ford engine. Worn fuel pumps rob power from your boat especially at high RPM's so help out your MasterCraft or Correct Craft Nautique with this new fuel pump. This is...

Rotor (86-Older) Prestolite Fits Ford and GM based V8 engines 1986 and older with a Prestolite distributor. Rotor only.Note: There were a FEW 1987 boats built that had the "old" CLIP-ON type distributor cap still.Please note: No returns will be accepted...

Indmar 160 Degree Thermostat LT1 Indmar 160 degree thermostat for Corvette LT-1 engines. This thermostat features two small holes that are drilled through to allow air to pass through the thermostat. This is the thermostat which is located in the LT-1...

Ilmor Manifold Air Temp Sensor (MAT Sensor)| MV8V-1052 Ilmor MAT Sensor for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for 5.7L 6.0L 6.2L Ilmor engines. Use the boat part look up below to ensure you are purchasing the correct...

Fuel Line Disconnect Tool The Fuel Line Disconnect Tool is an essential part of removing fuel lines! This tool makes quick work of removing the fuel lines from your in tank fuel pump. Removing the fuel line(s) is necessary to replace your fuel pump and...

Prestolite Points Fits all Ford and GM based V8 engines using a Prestolite points distributor. This is the Points only, tune up kits are available for these boat engines as well. These engines were used by MasterCraft, Malibu, Supra and Moomba boats...

Ilmor Engine Temperature Sensor | MV8V-1190 Ilmor water temperature sensors are engineered for precision and durability and the highest signal accuracy. Ilmor Engine Temp Sensor for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for...

Indmar Thermostat Gasket This thermostat gasket is commonly used on Indmar 350 block engines including the RTP-1, MCX, Assault and many others. This is a 3 bolt gasket used on the bottom half of the thermostat housing where it meets the intake manifold...

Ilmor Thermostat Housing O-Ring The Ilmor remote thermostat housing mounting o-ring offers application-specific materials to give you a sealing solution with the performance and durability you can trust. This Thermostat Housing O-Ring is used with both...

Ilmor O2 Sensor Upstream | MV8V-1017 Ilmor specified oxygen sensor is the recommended replacement for your Ilmor engine. The sensors provide special feedback to your engine’s exhaust system by measuring the proportion of oxygen in the exhaust gases...

Circulating Water Pump for Indmar & PCM Ford Engines Fits all Ford based engines from Indmar, PCM, etc.ξ This is a Bi-rotational pump. This new water circulating pump comes with a new mounting gasket to ensure a proper fit on your boat motor. New pump...

MasterCraft Water Sending Unit Sender-Water X30/X45If you do not see your boat model and year combination please email parts@waterskis.com to get the correct part. *PLEASE NOTE: ALL SALES ON SENDING UNITS ARE FINAL, AND ARE NON REFUNDABLE Model...

Ilmor O2 Sensor Downstream | MV8V-1018 Ilmor specified oxygen sensor is the recommended replacement for your Ilmor engine. The sensors provide special feedback to your engine’s exhaust system by measuring the proportion of oxygen in the exhaust gases...

Ilmor Spark Plug Wire Set | PL00224 Ilmor’s spark plug wire set consists of a set of 8 wires, encased in a premium insulating material, connectors, and insulating boots and are the high-quality and trusted replacement for your Ilmor engine. Ilmor...

Long Flexible Funnel For Oil and Transmission Fluid Long Flexible Funnel Fine mesh screen filters out most foreign matter. Non splashing. Lightweight floating polyethylene plastic. Makes putting oil and transmission fluid into hard to reach places a...

Indmar Spark Plug Wire Set | 755007 Get the spark your engine needs with new spark plug wire set. Fits Indmar Ford 351w, 302 (5.8, 5.0) Spark Plug Wire Set, based small blocks with either a Prestolite or a Mallory distributor. Complete set of 9 wires...

Ilmor Raw Water Pump Assembly Ilmor’s raw water pump assembly is specifically designed to keep your boat running cool and efficiently all season long. This factory direct part is tested and inspected prior to shipment, ensuring you receive a part you...

  This filter is no longer made and sold by MasterCraft. You can purchase the aftermarket replacement filter here -> Fuel Pump Filter for In-Tank Fuel Pumps - MasterCraft

Ilmor Marine Oil Filter This genuine Ilmor oil filter is made of high quality materials designed specifically for your Ilmor engine to keep it free of debris and contaminants. For ALL Ilmor MasterCraft engines (5.3, 5.7, 6.0, 6.2L, & 7.4). Ilmor...

Ilmor Starter Motor The Ilmor starter is the component that gets your engine running, providing ultimate cranking power for reliable and consistent engine starts every time. Use the boat part look up below to ensure you are purchasing the correct part...