Inboard Boat Parts

MasterCraft MMDC Box Mini M2 '07 Gauges not working after the winter or a cold snap? Your MMDC box is most likely the problem. Replace your MasterCraft MMDC Box and get everything back to working! This is an OEM MasterCraft specific part. ***Installed...

Custom MasterCraft Ballast Upgrade Kits These bags are custom designed to fit in 2006, 2007 or 2008 MasterCraft X-2, X-15, X-30, and X-45 wakeboard boats. Each bag adds aver 400 lbs. of ballast to help shape up your wake for monster air. That brings...

Rotor (86-Older) Prestolite Fits Ford and GM based V8 engines 1986 and older with a Prestolite distributor. Rotor only.Note: There were a FEW 1987 boats built that had the "old" CLIP-ON type distributor cap still.Please note: No returns will be accepted...

Indmar 160 Degree Thermostat Drilled Indmar 160 degree thermostat for Corvette LT-1 engines. This thermostat features two small holes that are drilled through to allow air to pass through the thermostat. This is the thermostat which is located in the...

Ilmor Manifold Air Temp Sensor (MAT Sensor)| MV8V-1052 Ilmor MAT Sensor for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for 5.7L 6.0L 6.2L Ilmor engines. Use the boat part look up below to ensure you are purchasing the correct...

Fuel Line Disconnect Tool The Fuel Line Disconnect Tool is an essential part of removing fuel lines! This tool makes quick work of removing the fuel lines from your in tank fuel pump. Removing the fuel line(s) is necessary to replace your fuel pump and...

MasterCraft Kill Switch This Kill Switch is used in MasterCrafts from 2006-Current. It is used in everything from a PS 197 to an X-Star. This switch can also be used in older MasterCraft boats by cutting the connector off and wiring in. Use the boat part...

MasterCraft Board Rack Bungee Cord This board rack bungee cord kit is for a MasterCraft X1 '05-'06. Use the boat part look up below to ensure you are purchasing the correct part for your boat.  

Prestolite Points Fits all Ford and GM based V8 engines using a Prestolite points distributor. This is the Points only, tune up kits are available for these boat engines as well. These engines were used by MasterCraft, Malibu, Supra and Moomba boats...

Ilmor Engine Temperature Sensor | MV8V-1190 Ilmor water temperature sensors are engineered for precision and durability and the highest signal accuracy. Ilmor Engine Temp Sensor for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for...

Rudder Cotter Pin 2" Long | 3/16 The Rudder Cotter Pin is a small but essential part. Replacing your cotter pin is cheap insurance and should never be overlooked. This is too important of a piece to be with out and letŒÍs face it, there is no way to...

Indmar Thermostat Gasket This thermostat gasket is commonly used on Indmar 350 block engines including the RTP-1, MCX, Assault and many others. This is a 3 bolt gasket used on the bottom half of the thermostat housing where it meets the intake manifold...

Ilmor Thermostat Housing O-Ring The Ilmor remote thermostat housing mounting o-ring offers application-specific materials to give you a sealing solution with the performance and durability you can trust. This Thermostat Housing O-Ring is used with both...

Master Lock - Trailer Coupler Lock Protect your trailer! This trailer lock fits UFP and Surge Brake Couplers with a 9/32 diameter.   Use the boat part look up below to ensure you are purchasing the correct part for your boat.  

MasterCraft 3 Position Rocker Switch Replace your worn or faded MasterCraft dash switches with this 3 position rocker switch. Features ON-OFF-ON capabilities. Easy installation and an exact fit. This switch has 3 positions and uses a 5 prong set up. This...

MasterCraft Red Port Side Navigation Light Replacement MasterCraft Red Port Side Navigation Light for use on many MasterCraft boats from 2005 to 2012. This light features a red led display for the port side only. The cover is finished in stainless steel...

Johnson Bilge Pump 750GPH This is a universal Johnson Bilge Pump 750GPH. Johnson Pump Pro-Line 12V Bilge Pump features a new efficient motor with greater torque and less amp draw. It can discharge water circulation for cooling and has a tough resin...

Ilmor O2 Sensor Upstream | MV8V-1017 Ilmor specified oxygen sensor is the recommended replacement for your Ilmor engine. The sensors provide special feedback to your engine’s exhaust system by measuring the proportion of oxygen in the exhaust gases...

Circulating Water Pump for Indmar & PCM Ford Engines Fits all Ford based engines from Indmar, PCM, etc.ξ This is a Bi-rotational pump. This new water circulating pump comes with a new mounting gasket to ensure a proper fit on your boat motor. New pump...

MasterCraft Muffler | 3.5" In w/45° Angle - 3.5" Out This is a genuine replacement fiberglass muffler for many MasterCraft boats. This muffler was typically used in direct drive boats made from 1994 to 2000 and features a 3.5" in and out with an average...