Inboard Boat Parts

MasterCraft Trailer Lights LED (Red) LED MasterCraft Trailer lights will not only outlast the traditional style they are brighter providing a safer driving experience both night and day. In addition, LED lights run very cool making them fully...

Bring your engine back to peak performance with this PCM Fuel Pump for your 302 or 351 Ford engine. Worn fuel pumps rob power from your boat especially at high RPM's so help out your MasterCraft or Correct Craft Nautique with this new fuel pump. This is...

MasterCraft MMDC Box Mini M2 '07 Gauges not working after the winter or a cold snap? Your MMDC box is most likely the problem. Replace your MasterCraft MMDC Box and get everything back to working! This is an OEM MasterCraft specific part. ***Installed...

Custom MasterCraft Ballast Upgrade Kits These bags are custom designed to fit in 2006, 2007 or 2008 MasterCraft X-2, X-15, X-30, and X-45 wakeboard boats. Each bag adds aver 400 lbs. of ballast to help shape up your wake for monster air. That brings...

Rotor (86-Older) Prestolite Fits Ford and GM based V8 engines 1986 and older with a Prestolite distributor. Rotor only.Note: There were a FEW 1987 boats built that had the "old" CLIP-ON type distributor cap still.Please note: No returns will be accepted...

Indmar 160 Degree Thermostat Drilled Indmar 160 degree thermostat for Corvette LT-1 engines. This thermostat features two small holes that are drilled through to allow air to pass through the thermostat. This is the thermostat which is located in the...

Ilmor Manifold Air Temp Sensor (MAT Sensor)| MV8V-1052 Ilmor MAT Sensor for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for 5.7L 6.0L 6.2L Ilmor engines. Use the boat part look up below to ensure you are purchasing the correct...

Fuel Line Disconnect Tool The Fuel Line Disconnect Tool is an essential part of removing fuel lines! This tool makes quick work of removing the fuel lines from your in tank fuel pump. Removing the fuel line(s) is necessary to replace your fuel pump and...

MasterCraft Kill Switch This Kill Switch is used in MasterCrafts from 2006-Current. It is used in everything from a PS 197 to an X-Star. This switch can also be used in older MasterCraft boats by cutting the connector off and wiring in. Use the boat part...

MasterCraft Board Rack Bungee Cord This board rack bungee cord kit is for a MasterCraft X1 '05-'06. Use the boat part look up below to ensure you are purchasing the correct part for your boat.  

Prestolite Points Fits all Ford and GM based V8 engines using a Prestolite points distributor. This is the Points only, tune up kits are available for these boat engines as well. These engines were used by MasterCraft, Malibu, Supra and Moomba boats...

Ilmor Engine Temperature Sensor | MV8V-1190 Ilmor water temperature sensors are engineered for precision and durability and the highest signal accuracy. Ilmor Engine Temp Sensor for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for...