Ilmor Water Pump Impeller This Ilmor Water Pump Impeller Kit is made from top quality materials specifically formulated to provide peak performance for use in your Ilmor raw water pump. Kit includes impeller and O-ring. This impeller is designed to work...

MasterCraft Trailer Lights LED (Red) ***LIGHT ONLY, NO GROMMET INCLUDED*** MasterCraft LED Trailer Lights will not only outlast the traditional style they are brighter providing a safer driving experience both night and day. In addition, LED lights run...

PCM Fuel Pump Assembly for Ford 302 and 351 Bring your engine back to peak performance with this PCM Fuel Pump for your 302 or 351 Ford engine. Worn fuel pumps rob power from your boat especially at high RPM's so help out your MasterCraft or Correct...

MasterCraft MMDC Box Mini M2 '07 Gauges not working after the winter or a cold snap? Your MMDC box is most likely the problem. Replace your MasterCraft MMDC Box and get everything back to working! This is an OEM MasterCraft specific part. ***Installed...

Rotor (86-Older) Prestolite Fits Ford and GM based V8 engines 1986 and older with a Prestolite distributor. Rotor only.Note: There were a FEW 1987 boats built that had the "old" CLIP-ON type distributor cap still.Please note: No returns will be accepted...

Indmar 160 Degree Thermostat LT1 Indmar 160 degree thermostat for Corvette LT-1 engines. This thermostat features two small holes that are drilled through to allow air to pass through the thermostat. This is the thermostat which is located in the LT-1...

Ilmor Manifold Air Temp Sensor (MAT Sensor)| MV8V-1052 Ilmor MAT Sensor for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for 5.7L 6.0L 6.2L Ilmor engines.  Tisi part cannot be returned if it is removed from the plastic bag it is...

MasterCraft Fuel Line Disconnect Tool The Fuel Line Disconnect Tool is an essential part of removing fuel lines from a MasterCraft Fuel Pump!This tool makes quick work of removing the fuel lines from your in tank fuel pump. Removing the fuel line(s) is...

MasterCraft Kill Switch This Kill Switch is used in MasterCrafts from 2006-Current. It is used in everything from a PS 197 to an X-Star. This switch can also be used in older MasterCraft boats by cutting the connector off and wiring in. Use the boat part...

Prestolite Points Fits all Ford and GM based V8 engines using a Prestolite points distributor. This is the Points only, tune up kits are available for these boat engines as well. These engines were used by MasterCraft, Supra, and Nautique.Please note: No...

Ilmor Engine Temperature Sensor | MV8V-1190 Ilmor water temperature sensors are engineered for precision and durability and the highest signal accuracy. Ilmor Engine Temp Sensor for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for...

HO Tail Weights HO Tail Weights are the perfect solution for water skiers struggling to get up on combo skis. Designed to easily attach to your HO combo skis rear fin screws, these compact weight units add significant adjustable tail weight to help skis...

Rudder Cotter Pin 2" Long | 3/16 The Rudder Cotter Pin is a small but essential part. Replacing your cotter pin is cheap insurance and should never be overlooked. This is too important of a piece to be with out and letŒÍs face it, there is no way to...

Indmar Thermostat Gasket This thermostat gasket is commonly used on Indmar 350 block engines including the RTP-1, MCX, Assault and many others. This is a 3 bolt gasket used on the bottom half of the thermostat housing where it meets the intake manifold...

Ilmor Thermostat Housing O-Ring The Ilmor remote thermostat housing mounting o-ring offers application-specific materials to give you a sealing solution with the performance and durability you can trust. This Thermostat Housing O-Ring is used with both...

Master Lock - Trailer Coupler Lock Protect your trailer! This trailer lock fits UFP and Surge Brake Couplers with a 9/32 diameter.   Use the boat part look up below to ensure you are purchasing the correct part for your boat.  

MasterCraft 3 Position Rocker Switch Replace your worn or faded MasterCraft dash switches with this 3 position rocker switch. Features ON-OFF-ON capabilities. Easy installation and an exact fit. This switch has 3 positions and uses a 5 prong set up. This...

Barefoot International Easy Footer with Instructional DVD The Barefoot International Easy Footer is one of the most important tools you can own because of the support it provides while training on the boom. It's virtually impossible to fall. The Easy...

MasterCraft Red Port Side Navigation Light Replacement MasterCraft Red Port Side Navigation Light for use on many MasterCraft boats from 2005 to 2012. This light features a red led display for the port side only. The cover is finished in stainless steel...

Johnson Bilge Pump 750GPH This is a universal Johnson Bilge Pump 750GPH. Johnson Pump Pro-Line 12V Bilge Pump features a new efficient motor with greater torque and less amp draw. It can discharge water circulation for cooling and has a tough resin...