Inboard Boat Parts

Ilmor Manifold Air Temp Sensor (MAT Sensor)| MV8V-1052 Ilmor MAT Sensor for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for 5.7L 6.0L 6.2L Ilmor engines.  Tisi part cannot be returned if it is removed from the plastic bag it is...

MasterCraft Fuel Line Disconnect Tool The Fuel Line Disconnect Tool is an essential part of removing fuel lines from a MasterCraft Fuel Pump!This tool makes quick work of removing the fuel lines from your in tank fuel pump. Removing the fuel line(s) is...

MasterCraft Kill Switch This Kill Switch is used in MasterCrafts from 2006-Current. It is used in everything from a PS 197 to an X-Star. This switch can also be used in older MasterCraft boats by cutting the connector off and wiring in. Use the boat part...

Prestolite Points Fits all Ford and GM based V8 engines using a Prestolite points distributor. This is the Points only, tune up kits are available for these boat engines as well. These engines were used by MasterCraft, Supra, and Nautique.Please note: No...

Ilmor Engine Temperature Sensor | MV8V-1190 Ilmor water temperature sensors are engineered for precision and durability and the highest signal accuracy. Ilmor Engine Temp Sensor for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for...

Rudder Cotter Pin 2" Long | 3/16 The Rudder Cotter Pin is a small but essential part. Replacing your cotter pin is cheap insurance and should never be overlooked. This is too important of a piece to be with out and letŒÍs face it, there is no way to...

Indmar Thermostat Gasket This thermostat gasket is commonly used on Indmar 350 block engines including the RTP-1, MCX, Assault and many others. This is a 3 bolt gasket used on the bottom half of the thermostat housing where it meets the intake manifold...

Ilmor Thermostat Housing O-Ring The Ilmor remote thermostat housing mounting o-ring offers application-specific materials to give you a sealing solution with the performance and durability you can trust. This Thermostat Housing O-Ring is used with both...

Master Lock - Trailer Coupler Lock Protect your trailer! This trailer lock fits UFP and Surge Brake Couplers with a 9/32 diameter.   Use the boat part look up below to ensure you are purchasing the correct part for your boat.  

MasterCraft 3 Position Rocker Switch Replace your worn or faded MasterCraft dash switches with this 3 position rocker switch. Features ON-OFF-ON capabilities. Easy installation and an exact fit. This switch has 3 positions and uses a 5 prong set up. This...

MasterCraft Red Port Side Navigation Light Replacement MasterCraft Red Port Side Navigation Light for use on many MasterCraft boats from 2005 to 2012. This light features a red led display for the port side only. The cover is finished in stainless steel...

Johnson Bilge Pump 750GPH This is a universal Johnson Bilge Pump 750GPH. Johnson Pump Pro-Line 12V Bilge Pump features a new efficient motor with greater torque and less amp draw. It can discharge water circulation for cooling and has a tough resin...

Ilmor O2 Sensor Upstream | MV8V-1017 Ilmor specified oxygen sensor is the recommended replacement for your Ilmor engine. The sensors provide special feedback to your engine’s exhaust system by measuring the proportion of oxygen in the exhaust gases...

Circulating Water Pump for Indmar & PCM Ford Engines Fits all Ford based engines from Indmar, PCM, as well as others.  This new bi-rotational pump comes with a new mounting gasket to ensure a proper fit on your Ford 302 or 351 boat motor...

MasterCraft Muffler | 3.5" In w/45° Angle - 3.5" Out This is a genuine replacement fiberglass muffler for many MasterCraft boats. This muffler was typically used in direct drive boats made from 1994 to 2000 and features a 3.5" in and out with an...

Ramp-N-Clamp Automatic Boat Latch No more wet feet and no more ramp delays while you crank your boat onto your trailer. Ramp-N-Clamp allows you to simply drive your boat onto your trailer and the bow-eye contacts the latch, automatically...

MasterCraft Toggle Switch Blue LED 2 Position 3 Prong MasterCraft Toggle Switch Two Position Switch with blue LED. This is a 2 position MasterCraft switch with 3 prongs used where a basic (ON/OFF) switch is required such as 2006 MasterCraft bilge pump...

MasterCraft Blue LED Toggle Switch MasterCraft Toggle Switch with blue LED. This is a 3 position MasterCraft switch with 5 prongs used where a 3 position (ON/OFF/ON) switch is required such as 2006 MasterCraft ballast toggles. This switch is used in many...

Supra Boat Matte Black Transom Decal 36" This 36" Supra Boats Matte Black Transom Decal is an OEM Supra Decal. This 36" Matte Black decal is designed to fit perfectly on your transom. You can also put this on the back window of your truck and show your...

MasterCraft Boats Swim Platform Pin These pins for your removable or folding MasterCraft swim platform are the perfect option whether yours are worn or at the bottom of the lake. Durable Stainless Steel design is superior to coated pins and provides...