Inboard Boat Parts

Rotor (86-Older) Prestolite Fits Ford and GM based V8 engines 1986 and older with a Prestolite distributor. Rotor only.Note: There were a FEW 1987 boats built that had the "old" CLIP-ON type...

Indmar 160 Degree Thermostat LT1 Indmar 160 degree thermostat for Corvette LT-1 engines. This thermostat features two small holes that are drilled through to allow air to pass through the thermostat...

Ilmor Manifold Air Temp Sensor (MAT Sensor)| MV8V-1052 Ilmor MAT Sensor for MasterCraft boats. Specifically designed by Ilmor and MasterCraft for 5.7L 6.0L 6.2L Ilmor engines.  Tisi part cannot be...

MasterCraft Fuel Line Disconnect Tool The Fuel Line Disconnect Tool is an essential part of removing fuel lines from a MasterCraft Fuel Pump!This tool makes quick work of removing the fuel lines from...

MasterCraft Kill Switch This Kill Switch is used in MasterCrafts from 2006-Current. It is used in everything from a PS 197 to an X-Star. This switch can also be used in older MasterCraft boats by...

Prestolite Points Fits all Ford and GM based V8 engines using a Prestolite points distributor. This is the Points only, tune up kits are available for these boat engines as well. These engines were...

Ilmor Engine Temperature Sensor | MV8V-1190 Ilmor water temperature sensors are engineered for precision and durability and the highest signal accuracy. Ilmor Engine Temp Sensor for MasterCraft...

Rudder Cotter Pin 2" Long | 3/16 The Rudder Cotter Pin is a small but essential part. Replacing your cotter pin is cheap insurance and should never be overlooked. This is too important of a piece...

Indmar Thermostat Gasket This thermostat gasket is commonly used on Indmar 350 block engines including the RTP-1, MCX, Assault and many others. This is a 3 bolt gasket used on the bottom half of the...

Ilmor Thermostat Housing O-Ring The Ilmor remote thermostat housing mounting o-ring offers application-specific materials to give you a sealing solution with the performance and durability you can...

Master Lock - Trailer Coupler Lock Protect your trailer! This trailer lock fits UFP and Surge Brake Couplers with a 9/32 diameter.   Use

MasterCraft 3 Position Rocker Switch Replace your worn or faded MasterCraft dash switches with this 3 position rocker switch. Features ON-OFF-ON capabilities. Easy installation and an exact fit. This...

MasterCraft Red Port Side Navigation Light Replacement MasterCraft Red Port Side Navigation Light for use on many MasterCraft boats from 2005 to 2012. This light features a red led display for the...

Johnson Bilge Pump 750GPH This is a universal Johnson Bilge Pump 750GPH. Johnson Pump Pro-Line 12V Bilge Pump features a new efficient motor with greater torque and less amp draw. It can discharge...

Ilmor O2 Sensor Upstream | MV8V-1017 Ilmor specified oxygen sensor is the recommended replacement for your Ilmor engine. The sensors provide special feedback to your engine’s exhaust system by...

Circulating Water Pump for Indmar & PCM Ford Engines Fits all Ford based engines from Indmar, PCM, as well as others.  This new bi-rotational pump comes with a new mounting gasket to ensure a proper...

MasterCraft Muffler | 3.5" In w/45° Angle - 3.5" Out This is a genuine replacement fiberglass muffler for many MasterCraft boats. This muffler was typically used in direct drive boats made from 1994...

Ramp-N-Clamp Automatic Boat Latch No more wet feet and no more ramp delays while you crank your boat onto your trailer. Ramp-N-Clamp allows you to simply drive your boat onto your trailer and the...

MasterCraft Toggle Switch Blue LED 2 Position 3 Prong MasterCraft Toggle Switch Two Position Switch with blue LED. This is a 2 position MasterCraft switch with 3 prongs used where a basic (ON/OFF)...

MasterCraft Blue LED Toggle Switch MasterCraft Toggle Switch with blue LED. This is a 3 position MasterCraft switch with 5 prongs used where a 3 position (ON/OFF/ON) switch is required such as 2006...